spiisolator9

---

SPI Isolator 9 Click

SPI Isolator 9 Click demo application is developed using the NECTO Studio, ensuring compatibility with mikroSDK's open-source libraries and tools. Designed for plug-and-play implementation and testing, the demo is fully compatible with all development, starter, and mikromedia boards featuring a mikroBUS™ socket.

---

Click Library

• Author : Stefan Filipovic
• Date : Sep 2024.
• Type : SPI type

Software Support

Example Description

This example demonstrates the use of SPI Isolator 9 Click board by reading the device ID of the connected Accel 22 Click board.

Example Libraries

• MikroSDK.Board
• MikroSDK.Log
• Click.SPIIsolator9

Example Key Functions

• spiisolator9_cfg_setup Config Object Initialization function.

  void spiisolator9_cfg_setup ( spiisolator9_cfg_t *cfg );

• spiisolator9_init Initialization function.

  err_t spiisolator9_init ( spiisolator9_t *ctx, spiisolator9_cfg_t *cfg );

• spiisolator9_write This function writes a desired number of data bytes by using SPI serial interface.

  err_t spiisolator9_write ( spiisolator9_t *ctx, uint8_t *data_in, uint8_t len );

• spiisolator9_read This function reads a desired number of data bytes by using SPI serial interface.

  err_t spiisolator9_read ( spiisolator9_t *ctx, uint8_t *data_out, uint8_t len );

• spiisolator9_write_then_read This function writes and then reads a desired number of data bytes by using SPI serial interface.

  err_t spiisolator9_write_then_read ( spiisolator9_t *ctx, uint8_t *data_in, uint8_t in_len, 
                                                            uint8_t *data_out, uint8_t out_len );

Application Init

Initializes the driver and logger.

void application_init ( void )
{
    log_cfg_t log_cfg;  
    spiisolator9_cfg_t spiisolator9_cfg;  

    LOG_MAP_USB_UART( log_cfg );
    log_init( &logger, &log_cfg );
    log_info( &logger, " Application Init " );
 
    // Click initialization.
    spiisolator9_cfg_setup( &spiisolator9_cfg );
    SPIISOLATOR9_MAP_MIKROBUS( spiisolator9_cfg, MIKROBUS_POSITION_SPIISOLATOR9 );
    if ( SPI_MASTER_ERROR == spiisolator9_init( &spiisolator9, &spiisolator9_cfg ) )
    {
        log_error( &logger, " Communication init." );
        for ( ; ; );
    }
    
    log_info( &logger, " Application Task " );
}

Application Task

Reads and checks the device ID of the connected Accel 22 Click board, and displays the results on the USB UART approximately once per second.

void application_task ( void )
{
    spiisolator9_get_accel22_id ( &spiisolator9 );
    Delay_ms( 1000 );
}

Note

Make sure to provide a VCC power supply on the VOUT side.

Application Output

This Click board can be interfaced and monitored in two ways:

• Application Output - Use the "Application Output" window in Debug mode for real-time data monitoring. Set it up properly by following this tutorial.
• UART Terminal - Monitor data via the UART Terminal using a USB to UART converter. For detailed instructions, check out this tutorial.

Additional Notes and Information

The complete application code and a ready-to-use project are available through the NECTO Studio Package Manager for direct installation in the NECTO Studio. The application code can also be found on the MIKROE GitHub account.

---